In the process of edge banding, the following factors mainly affect the quality of edge banding:
& nbsp; In the process of making the edge banding strip, it is now a mechanical operation. In such equipment, if the engine of the edge banding strip and the track are not well matched, stress will be generated between the edge banding strip and the plate section surface during the manufacturing process, which will make the edge of the edge banding strip not straight, which is not conducive to the trimming of the equipment. If the equipment is poor in commissioning, repair and maintenance, the quality problems caused by this are the most common and most lasting
& nbsp; Of course, in the process of edge banding, the processing error mainly comes from cutting and fine cutting. Because of the error of the equipment system and the processing error of the workers, the end face of the workpiece cannot reach the level and cannot be perpendicular to the adjacent face. Therefore, when edge sealing, this leads to the edge sealing strip cannot be completely removed from the end face of the plate. After edge sealing, there is a gap or the base material is exposed, which seriously affects the appearance
& nbsp; The edge banding is also affected by the environment. In winter, the edge banding is easy to harden, and its affinity to the adhesive decreases. In addition, the storage time is a little long, and the surface is aging, which will reduce the adhesive strength of the adhesive. Adhesive for edge banding This is a hot-melt adhesive for special edge banding. In winter, due to the low temperature, the temperature of glue should be slightly higher to ensure the glue and strength. In fact, the adhesiveness of the adhesive of the edge banding strip is to have an appropriate temperature so that it can have an appropriate affinity with the substrate
